Test and Debug Products

Bulls Eye® test point system for reduced board trace lengths, higher performance, lower cost and four times the high bandwidth signals in the same real estate as traditional SMA test systems. Test and debug cable systems in coax, twinax and shielded twisted pair designs to meet demanding emulation requirements.


EmulationEmulation

Test and debug cable systems designed to meet demanding emulation requirements.

Features
  • 50 ohm coax, 100 ohm twinax and shielded twisted pair cable assemblies
  • Single-ended and differential pair signal routing
  • Wide variety of pitches available
  • Ruggedizing features such as screw downs, strain relief, locks and latches
Series
V
  • ERCD
  • ERDP
  • ECDP
  • ERM8
  • ERF8
  • HSEC8-DV
  • SEAC
  • SEAF
  • SEAF-RA
  • EQRD
  • QRF8
  • QRM8
  • HQCD
  • HQDP
  • EQCD
  • EQDP
  • QTH
  • QSH
  • QTH-DP
  • QSH-DP
  • QTE
  • QSE
  • QTE-DP
  • QSE-DP
  • HHSC
  • SSW
  • SSQ
  • ESW
  • ESQ
  • BCS
  • SSM
  • TSW
  • MTSW
  • TSM
  • TSS
  • ZSS
  • FCS8
  • CJT-TH
  • CJT-BH
  • PCIE
  • PCIEC
  • FCF8
  • C28S
  • PCIE-LP
Emulation

Bulls Eye®Bulls Eye® RF High-Performance Test to 50 GHz

The high-density array designs and advanced cabling solutions within Samtec’s Bulls Eye® product family enable optimized performance, now to 50 GHz. Compression interface, small footprint and high cycle count make Bulls Eye® ideal for high-performance test applications.

Features
  • 50 GHz and 20 GHz high-performance test point systems (to 65 GHz in development)
  • Compression interface to the board for easy on/off and eliminate soldering costs
  • Small footprint design significantly saves space on the board
  • Microstrip (50 GHz) or stripline (50 & 20 GHz) PCB transmission
  • RF Technical Group: dedicated RF engineers provide personal support for meeting specific RF challenges
Series
V
  • BE40A
  • BDRA
  • BQRA
Bulls Eye®

A myriad of mechanical and electrical specifications must be considered when selecting the best connector system for your design. An incomplete, first-pass list of considerations include the type of termination, available footprint space, processing and operating temperature and ...
Doing business today isn’t quite like it was back in the 80’s. Sparkling teeth and x-ray vision shouldn’t be a side effect of a customer using your product. This, of course, is said in jest, but no longer do we sell only a product; but a product and physical, chemical, and electr...
Blockchain. Cryptocurrencies. Bitcoin mining. Algorithmic trading. These disruptive technologies depend on high-performance computing platforms for reliable execution. The financial services industry invests billions in hardware to support the near real-time services consumers re...
Samtec has released the industry’s first 0.50 mm pitch edge card socket with justification beam. This design allows high-speed signals to pass through an incredibly dense connector while keeping the mating PCB at a reasonable cost. The socket’s justification beam is designed to s...
In the Standards world, specifications are categorized to three ascending levels: Corporate, De Facto, and Industry Standard. Corporate Standards are achieved when design elements are adopted company-wide. De Facto Standards often grow out of a Corporate Standard to act as a solu...
View Full Site